Need to connect ADS and M-Bus? The Weble WBox routes ADS M-Bus natively: one gateway speaks both protocols and maps data points in real time — no PC, no middleware, no cloud dependency.

The protocols

ADS

ADS is the native protocol of Beckhoff TwinCAT PLCs.

ADS driver →

M-Bus

M-Bus reads heat, water, gas and electricity meters over a dedicated 2-wire bus.

M-Bus driver →

How the WBox bridges ADS and M-Bus

On the WBox you enable the ADS driver and the M-Bus driver, then map each point: a value read on the ADS side — the Beckhoff TwinCAT PLC protocol — is exposed on the M-Bus side — the metering bus — and vice-versa. Conversion, scaling and logic run on the gateway itself.

Route ADS M-Bus on your project

Find the right WBox gateway for your installation, or get in touch to validate your case.

Configure my gateway

← All routes