Need to connect LoRaWAN and KNX? The Weble WBox routes LoRaWAN KNX natively: one gateway speaks both protocols and maps data points in real time — no PC, no middleware, no cloud dependency.

LoRaWAN⇄WBoxgateway⇄KNXOne WBox gateway · native conversion · no PC

The protocols

LoRaWAN

LoRaWAN carries data from battery-powered sensors over several kilometres with very low power.

LoRaWAN driver →

KNX

KNX is the worldwide standard for home and building control, running over twisted-pair, IP or RF.

KNX driver →

Example deployment

Typical scenario LoRaWAN sensors into KNX A KNX building wants data from places cabling can't reach — a remote annexe, a parking level, a flood-prone basement. LoRaWAN sensors cover the distance, and the WBox turns their uplinks into KNX group objects, so the existing KNX visualisation shows wireless temperature, leak and level points alongside the rest. Technical documentation →

How the WBox bridges LoRaWAN and KNX

On the WBox you enable the LoRaWAN driver and the KNX driver, then map each point: a value read on the LoRaWAN side — long-range, low-power wireless — is exposed on the KNX side — the building field bus (lighting, blinds, HVAC) — and vice-versa. Conversion, scaling and logic run on the gateway itself.

Capacity & limits

  • LoRaWAN — LoRaWAN scales with the network server; device count is bounded by gateway coverage and airtime, not by the WBox.
  • KNX — KNX exposes the installation's group objects; a TP line carries up to 64 bus devices, extended through lines, areas and KNXnet/IP.

On the WBox, a driver licence enables the whole protocol — there is no artificial per-point tier to unlock. Capacity scales with the gateway model, from the compact S103 to the E413: you are bounded by the field bus, not by your licence.

Frequently asked questions

How do I connect LoRaWAN and KNX?

LoRaWAN is long-range, low-power wireless and KNX is the building field bus (lighting, blinds, HVAC). A single WBox gateway runs the LoRaWAN and KNX drivers, speaks both protocols at once and maps the data points between them — no PC, no middleware, no cloud dependency.

Is the LoRaWAN ⇄ KNX bridge bidirectional?

Yes. The WBox reads and writes on both sides: a value or command on the LoRaWAN side propagates to KNX, and vice-versa.

Do I need a PC, a PLC or proprietary hardware?

No. The LoRaWAN and KNX drivers are licence-activated on one WBox — no gateway PC, no intermediate PLC and no proprietary hardware.

Which WBox model do I need?

Any WBox with the LoRaWAN and KNX driver licences. The online configurator recommends the right model from your interfaces and point count. For KNX TP, choose the WBox S485 KNX, which has the twisted-pair interface on board.

Route LoRaWAN KNX on your project

Find the right WBox gateway for your installation, or get in touch to validate your case.

Configure my gateway

Related routes

← All routes